Since 2017 model the fork doesn't need to be upgraded for road use.
The origin preload is bad in the user manual.
For a 75 kg equiped pilot if should be set like this :
And for compression and rebound : 6 clics from max or 5 for more sport.
You want your bike to burn ?
The 2A circuit you're using (after replacing the fuse by a 5A) is not made for this, the cables are to small.
There is a special circuit allready protected by a 5 A fuse.
I've the same trouble IF the bike stands over rain a long time.
So if I've a doubt about weather I put something to protect starter switch.
And to reset the ECU error's code I also use the Ebay device. (link given)
Did you have your front tyre changed or wheel removed ?
There are 2 ways to install the sensor and one is bad. (the sensor is to far from the rotor and you may have this issue)
I had the problem.
Have a look at the pictures to compare with yours...
The wires are the same than the 5A circuits.
Yamaha has reduced the power to 2A due to alternator limit.
On my bike I've changed it to a 3A for many years (6 if I add my 2 MT09) to plug my heating grips.
To come back to compressor, I use this...
You have an other solution : hydraulic.
It's quite easy to adapt a Magura model.
The best is to contact them, they will build the exact lenght.
https://www.magura.com/fr/components/powersports/hydraulicclutchsystems/productdetailpage/?p=1853
It's much cheaper than to adapt the 2016 clutch.
If...
The stock bar diameter is 22 mm, and you must choose 220 mm long hand grip NOT 230 mm.
I'm satisfied by the tecnoglobe deluxe for more than 50 000 km. (on 2 different bikes)
For circuit use it's interesting to turn off the immobilizer because you also remove all the system to save weight.
On the 09 it's possible to do because it's not implemented in all the countries, it depends on the insurrance local law.
The police is using a laser/radar speed wich is perfect.
There cars/bikes are not homologated.
On my 2017 the error is between 8 and 10%, it depends on the tyres age. (8 when new, 10 when near the end)
All is linked to the battery.
If voltage is too low when trying to start, ECU will light on the engine light and avoid start.
Disconnecting the battery is not resetting the warning light, you must go to your dealer to do so. (Computer plugged under seat)
A way to force the start is to shunt the...
I use this connections (on 2017 model we have 2) for my heating grips and the charger.
I've changed the fuses for a 3A. (instead of 2)
No problems.
This is my second MT09 and I did the same on my old MT for more than 30 000 km.
If you check the wires you'll see that the wires are the same...
I've put the genuine yamaha model from my 2013 model on my 2017 model.
It's plug and play, the screws are in the same position and there is no problem with the rear lights.
For information it also fits MT10.