dragonclaw
New member
So I have a Akrapovic exhaust and i'm looking to design a baffle insert to replace the one already in. Just don't like the idea of modifying the stock one in case i want to use it again. I was going to take mine out and measure it but i went to take the baffle out and no luck. The baffle screw was offset from the out exhaust casing whole so it catches on the metal so i can't get it out.
I will get around to removing my baffle. In the mean time to get things moving could someone be nice enough to measure the baffle they have and pass the measurements to me. Main one being the outer diameter flange which has the captive nut on. Just then i can start CADing something up (My day job is a design engineer).
Once i have my prototype done (aka one for my bike) if anyone would like one i will get a batch of them machined if i get enough interest and see who much it would be. I'll stick some renderings up once i have it modeled.
Thanks
I will get around to removing my baffle. In the mean time to get things moving could someone be nice enough to measure the baffle they have and pass the measurements to me. Main one being the outer diameter flange which has the captive nut on. Just then i can start CADing something up (My day job is a design engineer).
Once i have my prototype done (aka one for my bike) if anyone would like one i will get a batch of them machined if i get enough interest and see who much it would be. I'll stick some renderings up once i have it modeled.
Thanks