A battery needs to have a very low impedance (internal resistance) to be able to supply high current.If some fault has increased the impedance the current will be limited and the battery won't turn the motor over.The voltage across the terminals won't show this.When automotive batteries fail it...
That is not the correct way to set the longer screw.You should set the allen screw to stop the rattle ( no more than 1/4 turn ) then set the longer screw so it just touches the allen screw with no tension and lock it.
The longer screw is just there to stop the allen screw backing out. The way...
A lot is made of using the latest expensive synthetic oils but in reality for 99% of users mineral oil,changed regularly, is perfectly adequate and using a synthetic in it's place would not show any detectable improvement in engine longevity.
Synthetics' only advantage is in low temperature...
I make and sell my own design oiler.On the MT you could use one of the fastening screws for the damper plate on the inside of the swingarm.
I got 93,000 km from my last 1250 Bandit chain and that did not need replacing because it had reached it's elongation limit (less than half worn) but one of...
You will have to remove the forks,take the top caps off and the springs and spacers ,just to pump out the old fluid with the damper rod.Then reverse the process to purge air from the cartridges.You cannot pump the damper rods with the springs in place.Upending the forks will not allow all the...
I use the X30 without a rack.I looked at the X40 but the 30 looks like it was made for the MT.
When expanded ,is more than large enough for several days worth of clothes etc.