Trip Hazard
New member
Has anybody fitted genuine Yamaha panniers to their 09 using the stays ?? I've acquired some, but it seems that the rear foot rests have to be removed in order for them to fit, not much use if you want to take a pillion.
just took a look at the reservoir and it does seem to jut in a bit. is there no spacers in the kit to move the footplate out a bit?Haven't tried to fit the near side yet, still trying to see why the offside won't fit, it seems that the reservoir is in the way.
ive seen them fitted to the demo bikes at the darkside downpour so there must be a spacer to move the res. out the way..No spacers with the stays, I got the set up of ebay, will try and fit the near side later and see what that looks like, i'll try to take some pics and post later
I'm guessing you checked this, but does the shape of the stay not allow for the reservoir to sit in front of it with the pipe running behind? Your picture looks like the problem is clearance for the pipe, not the reservoir. I'd be amazed if the product required for customers to make adapters to make it fit. Unless you bought an incomplete kit.Managed to get them fitted, I made some spacers 20mm diameter x 15mm long but they could be 20mm long as the reservoir is touching the stay, and are put together with 40mm button head set screws (50mm for the demo)
View attachment 2027
View attachment 2028
View attachment 2029
View attachment 2030
View attachment 2031
.
.
.
Did you have the same problem with the stays ?? The seat was done by PP seats B/hamI got the panniers for mine too (Wales tour last month) but I really like the look of that seat, where did you get it?
When you tighten it up without the spacers the reservoir bracket bends and the pipe gets trapped, I now have some deeper spacers, which when fitted should leave a small gap between the reservoir and the stay.I'm guessing you checked this, but does the shape of the stay not allow for the reservoir to sit in front of it with the pipe running behind? Your picture looks like the problem is clearance for the pipe, not the reservoir. I'd be amazed if the product required for customers to make adapters to make it fit. Unless you bought an incomplete kit.
No fitting instructions then? I think the pipe should run behind the pannier bracket with the reservoir in front, but that's just from looking at your first photo! I haven't fitted these myselfWhen you tighten it up without the spacers the reservoir bracket bends and the pipe gets trapped, I now have some deeper spacers, which when fitted should leave a small gap between the reservoir and the stay.
As for the right stay for the bike, I don't know as I can't see a part number. these were purchased secondhand.
I thought that but the stay is shaped, thus not allowing the stay to fit between the reservoir and the pipe.No fitting instructions then? I think the pipe should run behind the pannier bracket with the reservoir in front, but that's just from looking at your first photo! I haven't fitted these myself
I can see from your photos that the stays I've fitted to my bike, are not for a MT-09, yours look to hang a lot lower as the reservoir is well clear, as there is no part number on them, I'm unable to establish which bike these would fit so i'll have to nip down to me local yam shop and see if they can identify them, then sell em and get the right ones.I have uploaded four pics to photobucket